H110 overhead slewing crane- STEPA´s top-of-the-range model!
The advantages:
- STEPA´s largest arm profile for maximum service life
- adjustable slide packages on the telescopic boom
- equipped with two large electric motors as standard
- larger hydraulic tank for reduced oil heating
- two oil coolers as standard
- only available with the new XL air-con cabin
Specifications
- Up to 12.3m horizontal reach and 15m vertical reach
- Low maintenance and hard-wearing
- S700 fine grain steel
Technical information
-
Measurements -
Technical information
The best-selling boom system with high speeds and smooth operation achieved by using plastic rollers and low-maintenance extension ropes. This system has been exceptionally successful at STEPA both for agricultural and forestry use for over 20 years. The compressive lifting cylinder of STEPA’s load arm means low oil warming at higher working speeds during lifting and lowering of the load arm.
Specifications
- Up to 12m horizontal reach and 15m vertical reach
- Low maintenance and hard-wearing
- Boom system with high driving speed
- S700 fine grain steel
- Compressive lifting cylinders for minimal oil use and maximum speed
- 2 energy-saving LED headlamps as standard
Technical information
-
Measurements
Extremely narrow stables could be equipped with a crane for the first time after STEPA brought the quadruple telescopic crane onto the market in 1997 as the first manufacturer of what was then the Quattro crane. It also became possible to reach distances of up to 15m horizontally and 17m vertically.
Specifications
- Extremely small model size for narrow stables
- Can replace a cross bridge
- Protected design up to end of grapple
- S700 fine grain steel
- Compressive lifting cylinder for minimal oil use and maximum speed
- 2 energy-saving LED headlamps as standard
Technical information
-
Measurements -
Technical information